Why is the POWER LED not turning on?
Please check:1. Confirm 120VAC or 240VAC input power is connected correctly. 2. Verify input voltage. 3. Check whether the fuse on the circuit board has failed. The controller uses a 20 amp mini ATO fuse for protection.
Why is my salt chlorinator producing little or no chlorine?
Check the following:- Main switch is not set to OFF. - Increase the Desired Output % setting if needed. - Check stabilizer level. - Confirm pump running time is sufficient. - Verify salt level. - Inspect the cell for scaling.
Why is the CHECK SALT light flashing?
The CHECK SALT indicator flashes when salt level is low (below 2700 ppm).Please:1. Test pool salt level. 2. Add salt if needed. 3. Confirm the correct Turbo Cell type is selected.
Why is the GENERATING LED flashing?
The flashing GENERATING LED indicates the pool water temperature is outside the operating range.The system normally stops chlorine generation when water temperature drops below 50°F.
